TPMS System

TPMS DTC Troubleshooting: 83

DTC 83:

No VSP Signal

NOTE:

- If DTC 85 is also set, troubleshoot DTC 85 first.
- Check the fuel and emission systems DTCs with the HDS, and troubleshoot the PCM and F-CAN communication errors first: '07-09 models Initial Inspection and Diagnostic Overview, '10-11 models. Initial Inspection and Diagnostic Overview

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Test-drive the vehicle at 7 mph (10 km/h) or more.

4. Check the speedometer.

Does the speedometer register speed?

YES -

Go to step 5.

NO -

Update the PCM if it does not have the latest software: '07-09 models, '10-11 models, PCM Update or substitute a know-good PCM: '07-09 models Initial Inspection and Diagnostic Overview, '10-11 models, then go to step 1 TPMS System and recheck. If the PCM was updated and DTCs are not indicated, troubleshooting is complete. If the PCM was substituted and DTCs and not indicated, replace the original PCM: '07-09 models Service and Repair, '10-11 models Service and Repair.�

5. Check the VEHICLE SPEED in the TPMS DATA LIST with the HDS.

Is the vehicle speed indicated?

YES -

The system is OK at this time.�

NO -

Substitute a known-good TPMS control unit Service and Repair, and recheck.�