Interior Trim Removal/Installation - Rear Side Area

Interior Trim Removal/Installation - Rear Side Area

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to bend or scratch the trim or the panels.

1. Remove these items:

- Rear door opening seal, as needed Service and Repair
- Rear door sill trim Service and Repair
- Rear trim panel Interior Trim Removal/Installation - Cargo Area
- Cargo area floor Interior Trim Removal/Installation - Cargo Area

2. Remove the dual deck cargo shelf (A).






3. Pry out on the upper portion of the lid (A) with the appropriate trim tool to release the hooks (B), then remove it. From the opening hole of the lid, remove the bolt.






4. Remove the rear side trim panel (A).

1. Remove the clips (B, C) from the bottom portion of the trim panel.

2. Pull back the upper edge of the trim panel to release the upper hooks (D) from the quarter pillar glass trim (E).

3. Pull back the trim panel by hand to detach the clips (F).

4. Driver's side: Disconnect the cargo area accessory power socket connector (G).





5. Install the panel in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the cargo area accessory power socket connector is plugged in properly.
- When installing the panel, make sure it does not pinch the seat belt.
- Push the clips and the hooks into place securely.
- Before installing the seat belt anchor bolt, make sure there are no twists or kinks in the seat belt.