ODS Unit Replacement

ODS Unit Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the front passenger's seat Front Seat Removal/Installation and seat-back cover/pad Front Seat-back Cover/Pad Replacement.

3. Disconnect the ODS unit harness 18P connector (A) and OPDS sensor connectors (B) from the ODS unit (C).





4. Remove the two nuts (D) and the ODS unit.

Installation

1. Place the ODS unit (A) on the seat-back frame. Tighten the two nuts (B), and connect the ODS unit harness 18P connector (C) and OPDS sensor connectors (D) to the ODS unit.





2. Install the seat-back cover/pad in the reverse order of removal Front Seat-back Cover/Pad Replacement.

3. Install the front passenger's seat Front Seat Removal/Installation.

4. Do the battery terminal reconnection procedure Procedures.

5. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.

6. Clear any DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

7. Do the ODS unit Initialization Programming and Relearning.

8. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then go off.