A/T Clutch Pressure Control Solenoid Valve B And C Replacement

A/T Clutch Pressure Control Solenoid Valve B and C Replacement

1. Raise the vehicle on a lift, or apply the parking brake, block the rear wheels, and raise the front of the vehicle. Make sure it is securely supported.

2. Remove the splash shield Front Splash Shield Replacement.

3. Disconnect the connectors from A/T clutch pressure control solenoid valves B and C.





4. Remove A/T clutch pressure control solenoid valves B and C.

5. Remove the ATF joint pipes (A), the O-rings (D), and the gasket (E).

6. Clean the mounting surface, the fluid passage of the solenoid valve body, and transmission housing.

7. Install a new gasket on the transmission housing, and install the ATF joint pipes. Install new O-rings over the ATF joint pipes.

NOTE: Be sure to install a new gasket with the blue side toward the transmission housing.

8. Install A/T clutch pressure control solenoid valve B and C.

9. Check the connectors for rust, dirt, or oil, and clean or repair if necessary, then connect the connectors securely.

10. Install the splash shield Front Splash Shield Replacement.