A/T Main shaft Disassembly, Inspection, And Reassembly

A/T Mainshaft Disassembly, Inspection, and Reassembly

1. Inspect the thrust needle bearings and the needle bearings for galling and rough movement.





2. Inspect the splines for excessive wear and damage.

3. Check shaft bearing surface for scoring and excessive wear.

4. Before installing new O-rings, wrap the shaft splines with tape to prevent O-ring damage.

5. Lubricate all parts with ATF during assembly.

6. Install the conical spring washer and the 41 x 68 mm thrust washer in the direction shown.

7. Replace the locknut and the conical spring washer with new ones when assembling the transmission.

8. Check the 5th gear axial clearance A/T Mainshaft 5th Gear Axial Clearance Inspection.