Transmission Mount: Service and Repair

Transmission Mount Replacement

1. Loosen the upper torque rod mounting bolt (A).






2. Remove the air cleaner.

3. Remove the air intake duct.

- K24Z6 engine Removal and Replacement

4. Remove the PCM cover, then remove the three bolts securing the PCM Engine Removal.

NOTE: Do not disconnect the PCM connector.

5. Remove the PCM bracket Engine Removal.

6. Support the transmission with a jack and a wood block under the transmission.

7. Remove the transmission mount stiffener (A) and the transmission mount (B).





8. Install the transmission mount with the new mounting bolts (C), then install the transmission mount stiffener, and tighten the mounting bolts in the numbered sequence shown.

9. Loosely install the new bolt and nuts (D).

10. Remove the jack and a wood block from under the transmission.

11. Raise the vehicle on the lift.

12. Loosen the lower torque rod mounting bolt (A).






13. Lower the vehicle on the lift.

14. Tighten the transmission mounting bolt and nuts.






15. Raise the vehicle on the lift.

16. Tighten the lower torque rod mounting bolt.






17. Lower the vehicle on the lift.

18. Tighten the upper torque rod mounting bolt.






19. Install the PCM bracket Engine Installation.

20. Install the PCM, then install the PCM cover Engine Installation.

21. Install the air cleaner.

22. Install the air intake duct.

- K24Z6 engine Removal and Replacement