Manufacturer Code Charts: 2608

Navigation System DTC Troubleshooting: 2608

DTC 2608:

Rear Camera Diag

NOTE:

- Check the vehicle battery condition first Testing and Inspection.
- This navigation DTC sets when a communication error between the rearview camera and the audio-navigation unit (open or short) is detected.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.

1. Clear the hard error code.

2. Turn the ignition switch to LOCK (0), and then back to ON (II).

3. Go into the System Diagnostic Mode, and select the Self-Diagnosis Mode in the Select Diagnosis Items menu Navigation System Diagnostic Mode.

4. Check the System Links.

Is the Rear camera icon red?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. If the vehicle repeatedly comes back with the navigation DTC, replace the audio-navigation unit Audio-Navigation Unit Removal/Installation (With Navigation).�

5. Check for poor connection or loose terminal at the rearview camera 12P connector.

Are the connections OK?

YES -

Go to step 6.

NO -

Repair poor connection or loose terminal.�

6. Turn the ignition switch to LOCK (0).

7. Disconnect the rearview camera 12P connector.

8. Turn the ignition switch to ON (II).

9. Measure the voltage between rearview camera 12P connector terminal No. 12 and body ground.





Is there about 3.0 V?

YES -

Replace the rearview camera Service and Repair.�

NO -

Go to step 10.

10. Measure the voltage between audio-navigation unit connector G (7P) terminal No. 7 and body ground.





Is there about 3.0 V?

YES -

Repair an open in the wire between the audio-navigation unit and the rearview camera.�

NO -

Replace the audio-navigation unit Audio-Navigation Unit Removal/Installation (With Navigation).�