DTC Troubleshooting

DTC Troubleshooting: P1298, P1298

DTC P1298:

ELD Circuit High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Initial Inspection and Diagnostic Overview.

1. Turn the ignition switch to ON (II).

2. Check the ELD in the DATA LIST with the HDS.

Is 0.2 A or less indicated?

YES -

Go to step 3.

NO -

Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the ELD and the ECM/PCM.�

3. Turn the ignition switch to LOCK (0).

4. Disconnect the ELD 3P connector.

5. Turn the ignition switch to ON (II).

6. Measure the voltage between ELD 3P connector terminal No. 1 and body ground.





Is there battery voltage?

YES -

Go to step 7.

NO -

Check the No. 4 ACG (10 A) fuse in the under-dash fuse/relay box. If the fuse is OK, repair open in the wire between the No. 4 ACG (10 A) fuse and the ELD, then go to step 14.

7. Turn the ignition switch to LOCK (0).

8. Jump the SCS line with the HDS.

9. Disconnect ECM/PCM connector E (31P).

10. Connect ELD 3P connector terminal No. 3 to body ground with a jumper wire.






11. Check for continuity between ECM/PCM connector terminal E15 and body ground.





Is there continuity?

YES -

Go to step 12.

NO -

Repair open in the wire between the ECM/PCM(E15) and the ELD, then go to step 14.

12. Check for continuity between ELD 3P connector terminal No. 2 and body ground.





Is there continuity?

YES -

Go to step 13.

NO -

Repair open in the wire between the ELD and G301;'07-08 models except SC, '07-08 models SC, '09-11 models, then go to step 14.

13. Replace the ELD Service and Repair.

14. Reconnect all connectors.

15. Turn the ignition switch to ON (II).

16. Reset the ECM/PCM with the HDS.

17. Do the ECM/PCM idle learn procedure ECM/PCM Idle Learn Procedure.

18. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P1298 indicated?

YES -

Go to step 19.

NO -

Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.�

19. Update the ECM/PCM if it does not have the latest software ECM/PCM Update, or substitute a known-good ECM/PCM.

20. Check for Pending or Confirmed DTCs with the HDS.

Is DTC P1298 indicated?

YES -

Check for poor connections or loose terminals at the ELD and the ECM/PCM. If the ECM/PCM was updated, substitute a known-good ECM/PCM, then recheck. If the ECM/PCM was substituted, go to step 1.

NO -

If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM ECM/PCM Replacement (A/T). If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.�