Rear Door Striker: Adjustments

Rear Door Striker Adjustment

Make sure the door latches securely without slamming it. If necessary, adjust the upper and lower strikers at the same time.

1. Remove these items:

- Upper striker cover
- Door sill trim Service and Repair

2. Adjust the upper striker (A) and the lower striker (B):

- Loosen the upper striker mounting bolts (C) slightly, and move the striker in or out until the upper edge of the door is flush with the body. Install and/or remove shims (D) until the striker is centered in the upper latch.
- Loosen the lower striker mounting screws (E) slightly, and move the striker in or out until the bottom edge of the door is flush with the body. Move the striker forward or rearward until the striker is centered in the lower latch.





3. Lightly tighten the bolts and the screws.

4. Hold the door handle (F) out, and push the door against the body to be sure the strikers allow a flush fit. If the door latches properly, tighten the bolts and the screws to the specified torque, and recheck.

5. Check the door unlock synchronization. If necessary, adjust the upper and the lower latch cables Adjustments.