Blower Unit Removal/Installation

Blower Unit Removal/Installation

1. Remove the passenger's dashboard undercover Passenger's Dashboard Undercover Removal/Installation, the passenger's kick panel Service and Repair, and the glove box Service and Repair.

2. Cut the plastic cross brace in the glove box opening with diagonal cutters in the area shown. Remove and discard the plastic cross brace.






3. Remove the relays (A) and detach the wire harness clip (B), and (C) (with navigation). Then remove the bolts and the glove box frame (D).






4. Remove the ECM/PCM ECM/PCM Replacement (A/T).

5. Disconnect the connectors (A) from the blower motor, the power transistor, and the recirculation control motor, then detach the wire harness clips (B).






6. Fold the floor covering and pad back toward you. Remove the mounting bolts, the mounting nut, and the blower unit.





7. Install the unit in the reverse order of removal. Make sure that there is no air leakage.