Rear Stabilizer Bar Replacement

Rear Stabilizer Bar Replacement

NOTE: Except SC model is shown, other model is similar.

1. Raise and support the vehicle Service and Repair.

2. Remove the rear wheels.

3. Disconnect both side of the stabilizer link from the stabilizer bar Rear Stabilizer Link Removal/Installation.

4. Remove the flange bolts (A) and the bushing holders (B), then remove the bushings (C) and the stabilizer bar (D).






5. Install the stabilizer bar in the reverse order of removal, and note these items:

- Make sure the right and left ends of the stabilizer bar are installed on their respective sides of the vehicle.
- Align the paint marks (A) on the stabilizer bar with the sides of the bushings (B).
- Note the direction of installation for the bushing.
- Refer to stabilizer link removal/installation to connect the stabilizer bar to the links Rear Stabilizer Link Removal/Installation.
- Before installing the wheel, clean the mating surfaces between the brake disc/drum and the inside of the wheel.