B2083

DTC Troubleshooting: B2083

DTC B2083:

Right Power Slide Motor Circuit Malfunction

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Turn the ignition switch to LOCK (0), and then back to ON (II).

2. Turn the power sliding door main switch ON.

3. Operate the open side of the right power sliding door switch four or more times.

4. Clear the DTCs with the HDS.

5. Check for DTCs with the HDS.

Is DTC B2083 indicated?

YES -

Go to step 6.

NO -

Intermittent failure, the power sliding door system is OK at this time. Check for loose or poor connections at the right power sliding door control unit connector, and at the right power slide motor connectors.�

6. Turn the ignition switch to LOCK (0).

7. Disconnect right power sliding door control unit connector C (5P).

8. Disconnect the 2P connector from the right power slide motor assembly.

9. Check for continuity between right power sliding door control unit connector C (5P) terminals No. 3 and No. 5 and body ground individually.





Is there continuity?

YES -

Repair a short to ground in the wire.�

NO -

Go to step 10.

10. Do the right power slide motor test Power Sliding Door Slide Motor Test.

Is the motor OK?

YES -

Replace the right power sliding door control unit.�

NO -

Replace the right power slide motor assembly.�