B2085

DTC Troubleshooting: B2085

DTC B2085:

Right Power Sliding Door Half Latch Switch Circuit Short

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0), and then back to ON (II).

3. Turn the power sliding door main switch ON.

4. Close the right power sliding door.

5. Open the right power sliding door fully with the right power sliding door switch.

6. Check for DTCs with the HDS.

Is DTC B2085 indicated?

YES -

Go to step 7.

NO -

Intermittent failure, the power sliding door system is OK at this time. Check for loose or poor connections at the right power sliding door control unit connectors, and at the right power sliding door rear latch assembly connectors.�

7. With the door open, select POWER SLIDING DOOR with the HDS, and enter the DATA LIST.

8. Check the ON/OFF information of the power sliding door R. Half Latch Switch in the DATA LIST.

Is the information indicator OFF?

YES -

Replace the right power sliding door control unit.�

NO -

Go to step 9.

9. Turn the ignition switch to LOCK (0).

10. Disconnect the 6P connector from the right power sliding door rear latch assembly.

11. Turn the ignition switch to ON (II).

12. Check the ON/OFF information of the power sliding door R. Half Latch Switch in the DATA LIST.

Is the information indicator OFF?

YES -

Replace the right power sliding door rear latch assembly.�

NO -

Go to step 13.

13. Disconnect the right power sliding door control unit connector B (12P).

14. Check for continuity between right power sliding door control unit connector B (12P) terminal No. 3 and body ground.





Is there continuity?

YES -

Repair a short to ground in the wire.�

NO -

Replace the right power sliding door control unit.�