85-71

SRS DTC Troubleshooting: 85-71, 85-78

DTC 85-71, 85-78:

OPDS/ODS Unit Not Initialized

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair and General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.

1. Clear the DTC memory Reading and Clearing Diagnostic Trouble Codes.

2. Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

3. Read the DTC Reading and Clearing Diagnostic Trouble Codes.

Does the SRS indicator stay on, and is DTC 85-71 or 85-78 indicated?

YES -

Go to step 4.

NO -

Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures Reading and Clearing Diagnostic Trouble Codes. If another DTC is indicated, troubleshoot the DTC.�

4. Clear the DTC memory Reading and Clearing Diagnostic Trouble Codes

5. Do the OPDS/ODS unit initialization.

- '07 model: OPDS unit OPDS Unit Initialization
- '08-10 models: ODS unit Programming and Relearning

6. Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator go off?

YES -

The system is OK.�

NO -

Go to step 7.

7. Replace the OPDS/ODS unit, then clear the DTC.

- '07 model: OPDS unit OPDS Unit Replacement
- '08-10 models: ODS unit ODS Unit Replacement

8. Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator go off?

YES -

The system is OK.�

NO -

Replace the SRS unit SRS Unit Replacement.�