Shift Interlock Switch: Service and Repair

Park Pin Switch Replacement

1. Remove the shift lever assembly A/T Shift Lever Removal.

2. Remove the tape from the harness.

3. Remove the harness wire tie.





4. Remove the A/T gear position indicator panel, and move it up.

5. Pry the lock covers (A) of the D3 switch/park pin switch/A/T gear position indicator panel light harness connector (B), and remove the covers.





6. Remove the terminal (C) from the connector by pushing the lock tab (D) in the connector using a thin-bladed screwdriver (E). Remove all six terminals, and replace the connector.

7. Remove the park pin switch (A).





8. Install a new park pin switch, and install the A/T gear position indicator panel.

9. Install the D3 switch harness terminals (WHT) (A) in the No. 1 and No. 3 cavities. Either terminal can go in either cavity.





10. Install the park pin switch harness terminals (GRN) (B) in the No. 2 and No. 6 cavities. Either terminal can go in either cavity.

11. Install the A/T gear position indicator panel light harness terminals (RED/BLK) (C) in the No. 4 and No. 5 cavities. Either terminal can go in either cavity.

12. Make sure that all six terminals lock securely, then install the lock covers (D) securely.

13. Route the harnesses along the harness guide (A), and tie the harnesses and guide with a new wire tie (B).






14. Tie the harnesses together into bundles with new tape (A) in two places.





15. Tie the harnesses and the harness clamp (B) together into a bundle with tape (C) as shown.

16. Install the shift lever assembly A/T Shift Lever Installation.