Imoes Unit Input Test/Replacement (USA)

Imoes Unit Input Test/Replacement

'08-10 USA models

1. Remove the dashboard Overhaul.

2. Remove the bolt and the imoes unit (A).





3. Disconnect the 5P connector (B) from the imoes unit.

4. Inspect the connector and socket terminals to be sure they are all making good contact.

- If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
- If the terminals look OK, go to step 5.

5. With the connectors still disconnected, do these input tests at the following connector.

- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, replace the imoes unit, then do the imoes unit registration with the HDS, and make sure the immobilizer indicator blinks correctly.