Power Sliding Door Module: Testing and Inspection

Resetting the Power Sliding Door Control Unit

NOTE: If the battery terminal is disconnected or No. 7 (7.5 A) fuse in the driver's under-dash fuse/relay box is removed while the power sliding door is operating, the power sliding door can not be opened or closed automatically until it is reset.

1. Erase the power sliding door DTCs by removing the No. 7 fuse from the under-dash fuse/relay box.

2. Turn off the Main switch for the doors. Make sure the ignition switch is in LOCK (0).

3. Fully close the power sliding door manually (the control unit must see the full latch switch and the ratchet switch closed at the same time).

4. Turn the ignition switch to ON (II). Turn on the Main switch.

5. Test the door operation with the power sliding door switch, the remote transmitter, and the door handles.