Transmission Fluid Pressure Switch A (2nd Clutch) Replacement

Transmission Fluid Pressure Switch A (2nd Clutch) Replacement

1. Do the battery removal procedure Procedures.

2. Remove the auxiliary under-hood fuse/relay box from its bracket, and remove the bracket from the battery base.

3. Remove the intake air duct and the air cleaner housing.

4. Remove the battery base and the battery base bracket.

5. Disconnect the transmission fluid pressure switch A (2nd clutch) connector, and remove the transmission fluid pressure switch A (2nd clutch) (A).





6. Install a new transmission fluid pressure switch A (2nd clutch) and a new sealing washer (B), and tighten the switch.

7. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

8. Install the battery base bracket and the battery base.

9. Install the air cleaner housing and the intake air duct.

10. Install the auxiliary under-hood fuse/relay box on the battery base, and install the fuse/relay box on its bracket.

11. Do the battery installation procedure Procedures.