Windshield Moulding / Trim: Service and Repair

Windshield Side Trim Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Take care not to damage the windshield.
- Take care not to bend the side windshield trim.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the side windshield trim (A).

1. Carefully insert a trim tool under the windshield side trim next to the clip (B), then pry the trim up to release the clip.

2. While pulling the retainer section of the trim up with a trim tool, push each of the four small hooks (C) with a small flat-tip screwdriver to release the trim from the retainer (D) on the A-pillar. Do not pry on the windshield trim anywhere except the retainer section.

3. Gradually work your way up to release the trim from each of the retainers.





2. Install the trim in the reverse order of removal, and note these items:

- Make sure the trim is installed securely.
- Replace any damaged retainer.

Retainer Replacement

1. Gradually separate the adhesive tape (A) under the retainers (B) while heating them with a heat gun to about 212-248 degrees F (100-120 degrees C).

NOTE:

- Do not overheat the painted surface around the retainers.
- To keep the exterior plastic parts near the A-pillar from being overheated by a heat gun, wrap them with an aluminum foil.





2. Using isopropyl alcohol on a shop towel, clean the body bonding surface. After cleaning, keep oil, grease, and water from getting on the surface.

3. Install the retainers (A).

1. Peel the adhesive backing away from the retainers.

2. Line up the retainers with the alignment marks (B) on the body, and attach them with adhesive tape (C).

3. Apply epoxy two-part adhesive (D) around the edge of the retainers as shown.