Front Seat Recline Cover Removal/Installation

Front Seat Recline Cover Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.
- Take care not to tear the seams or damage the seat covers.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Manual Seat

1. Remove the front seat Front Seat Removal/Installation (USA/Canada).

2. Pull back the cap (A) to release the hooks (B). Remove the TORX screw (C) and the screw (D), then remove the height adjuster handle (E).

Driver manual height adjustable seat





3. Remove the recline outer cover (A).

1. Put the seat-back in the fully upright position.

2. Remove the recline knob (B), and remove the TORX screw.

3. Detach the clip by pulling the outer cover back by hand.

4. Release the hooks (C) along upper edge of the outer cover with a trim tool.

Driver's manual height adjustable seat





Passenger's manual seat





4. Remove the center cover (A).

1. Remove the TORX screw.

2. Release the hooks (B).





5. Install the recline covers in the reverse order of removal. Push the clips and the hooks into place securely.

Power Seat

1. Remove the front seat Front Seat Removal/Installation (USA/Canada).

2. Remove the TORX screw and release the hooks (A), then remove the front cover (B).






3. Remove the recline cover (A).

1. Remove the TORX screw, and detach the clip and the hooks (B).

2. Pull up the cover, then detach the hooks (C, D).

3. Disconnect the 12P connector (E) from the power seat adjustment switch. Driver's side: Disconnect the 5P connector (F) from the power lumbar support switch.

4. Gently pull out the outer cover, and remove it.

Driver's seat





Passenger's seat





4. Remove the center cover (A).

1. Remove the TORX screw.

2. Pull up the cover, then detach the hooks (B).





5. Install the recline covers in the reverse order of removal:

- Push the clips and the hooks into place securely.
- Make sure the connectors are plugged in properly.