Shift Interlock Switch: Service and Repair

Park Pin Switch Replacement

NOTE:

- The A/T gear position indicator panel light harness is not available separately from the park pin switch and the D3 switch connector harness; replace the A/T gear position indicator panel light harness/park pin switch/D3 switch connector harness, and the connector as a set.
- Refer to the Shift Lever Disassembly and Reassembly A/T Shift Lever Disassembly/Reassembly as needed during the following procedures.

1. Remove the shift lever assembly A/T Shift Lever Removal.

2. Disconnect the D3 switch connector (A), and remove the harness connector clip (B).






3. Remove the A/T gear position indicator panel light socket (A) from the A/T gear position indicator panel (B), and remove the A/T gear position indicator panel light bulb (C) from the socket.






4. Remove the park pin switch (A) by expanding its locks (B) from the shift lever. Remove the A/T gear position indicator panel light harness/park pin switch/D3 switch connector harness (C).






5. Replace the A/T gear position indicator panel light harness/park pin switch/D3 switch connector harness.

6. Install the light bulb in the A/T gear position indicator panel light socket.

7. Install the A/T gear position indicator panel light socket (A) in the A/T gear position indicator panel (B).






8. Install the D3 switch connector clip (A), and connect the D3 switch connector (B).






9. Install the shift lever assembly A/T Shift Lever Installation.