In-Bed Trunk Lid Main Switch Test/Replacement

In-Bed Trunk Lid Main Switch Test/Replacement

1. Remove the glove box Glove Box Removal/Installation.

2. Carefully push the main switch (A) out.





3. Disconnect the 2P connector (B) from the main switch.

4. Check for continuity between terminals No. 1 and No. 2.

- With the main switch ON, there should be continuity.
- With the main switch OFF, there should be no continuity.

5. If the continuity is not as specified, replace the main switch.

6. Install the switch in the reverse order of removal.