Removal and Installation

1. Remove master cylinder as outlined under Master Cylinder, Brakes.
2. Disconnect vacuum hose from booster, then remove vacuum hose bracket.
3. Remove throttle control cable bracket.
4. Remove wiring harness from clamp.
5. On models with M/T, remove clutch reservoir and reservoir bracket.
6. Loosen pushrod locknut, then remove the cotter pin and clevis pin.
7. Remove clevis from operating rod of booster.
8. Remove four booster mounting nuts, then pull booster forward and turn right until operating rod is clear of bulkhead, then remove booster from engine compartment.
9. Reverse procedure to install. Adjust pushrod length before installing booster.