Part 2

30. Remove the air conditioning (A/C) compressor.
- Do sot disconnect A/C hoses.






31. Raise the hoist to full height. then remove the center beam.






32. Remove the exhaust pipe A.
33. Disconnect the heated oxygen sensor (H02S) connector (F22B1 engine only).
- Except sedan LX without ABS model of Engine Serial Number: F22B2 - 21XXXXX.






- Sedan LX without ABS model of Engine Serial Number: F22B2 -21XXXXX.






34. Remove the shift cable (A/T).


NOTE:

- Take care not to bend the cable when removing it. Always replace any kinked cable with a new one.
- Adjust the shut cable when installing.
35. Remove the damper fork.






36. Disconnect The suspension lower arm ball joints with the special tool.

NOTE: Adjust the tool so the jaws are parallel to each other.

37. Remove the driveshafts.

CAUTION:
- Do not pull on the driveshaft, the CV joint may come apart.






- Use care when prying out the assembly. Pull it straight to avoid damaging the differential oil seal or intermediate shaft dust seal.






NOTE: Coat all precision-finished surfaces with clean engine oil. Tie plastic bags over the driveshaft ends.
38. Lower the hoist.






39. Attach the chain hoist to the engine as shows.






4O. Remove the rear mount bracket.






41. Remove the front mount bracket.






42. Remove the side engine mount.






43. Remove the transmission mount and bracket.
44. Check that the engine it completely tree or vacuum hose, fuel and engine coolant hose, and electrical wiring.
45. Slowly raise the engine approximately 150 mm (6 in). Check once again that all hoses and wires are disconnected from the engine.
46. Raise the engine all the way and remove it from the car.