Mirrors: Service and Repair
MirrorsPower Mirror Replacement
1. Pry out the cover panel with a flat tip screwdriver, then remove it.
CAUTION: When prying with a flat tip screwdriver, wrap it with protective tape to prevent damage.
2. Disconnect the connector. Remove the nuts, then remove the mirror while holding it.
3. Installation is the reverse of the removal procedure.
Manual Mirror Replacement
1. Remove the cap and screw, then remove the control knob
2. Pry out the cover panel with a flat tip screwdriver, then remove it.
CAUTION: When prying with a flat tip screwdriver,
wrap it with protective tape to prevent damage.
3. Remove the nuts, then remove the mirror while holding it.
4. Installation is the reverse of the removal procedure.
Mirror Holder Replacement
Power mirror:
1. Insert a screwdriver in the mirror housing through the service hole, and loosen the actuator retaining screw.
2. Pull out the mirror holder from the mirror housing.
3. Pull the lock cap stopper and remove the stopper pin, then separate the actuator and mirror holder.
NOTE: If the mirror is equipped with a defogger, you cannot separate the actuator and mirror holder.
4. Installation is the reverse of the removal procedure.
NOTE: Apply grease to the locations indicated by the arrows.
Manual mirror:
1. Carefully pry out the mirror holder with a flat tip screwdriver as shown.
CAUTION:To prevent damage to the mirror, wrap the end of a flat tip screwdriver with a shop towel.
2. Installation is the reverse of the removal procedure.
NOTE: Apply grease to the locations indicated by the arrows.
Mirrors
Mirror Visor and Mirror Cover Replacement
NOTE: The mirror visor and mirror cover replacement procedures shown are for the power mirror. The manual mirror visor and cover can be replaced in the same manner.
1. Remove the mirror holder.
2. Turn the mirror base forward, then remove the screws.
3. Detach the hooks, then remove the mirror visor.
4. Remove the screws, then remove the mirror cover.
5. Installation is the reverse of the removal procedure.