Console: Service and Repair

NOTE: SRS wire harnesses are routed near the front console.

CAUTION:
- All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
- Whenever the ignition switch ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.

FRONT AND REAR CONSOLE REPLACEMENT

NOTE: Take care not to scratch the front and rear consoles, front seats and dashboard.

CAUTION: When prying with a flat tip screwdriver, wrap it with protective tape to prevent damage.





1. Open the armrest and remove the inner panel.





2. Remove the access lid and screws.





3. Remove the beverage holder and screw.





4. Remove the rear console.

NOTE:
- Lift up the parking brake lever.
- Detach the hooks by lifting the front of the rear console and sliding it rearward.





5. Remove the ashtray and screws.





6. Detach the clips by lifting the console panel, and disconnect the connectors.

NOTE:
- Take care not to scratch the shift lever and A/T gear position indicator panel.
- Remove the shift lever knob (M/T).





7. Remove the bolts, then remove the stereo radio/ cassette and pocket by pulling it out. Disconnect the connector and antenna lead.

NOTE: The original radio has a coded theft protection circuit. Be sure to get the customer's code number before:
- disconnecting the battery.
- removing the No. 39 (7.5 A) fuse from the under-hood fuse/relay box.
- removing the radio.
After service, reconnect power to the radio and turn it on. When the word "CODE" is displayed, enter the customer's 5-digit code to restore radio operation.

8. Remove:
- Dashboard lower cover
- Glove box





9. Remove the screws.





10. Remove the front console.

NOTE: Wrap the shift lever and A/T gear position indicator panel with a shop towel to prevent damage.

11. Installation is the reverse of the removal procedure.