Blower Motor Resistor: Service and Repair

CAUTION:
- All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag connectors.
- Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could accidentally deploy and cause damage or injuries.
- For additional precautions, refer to Air Bags and Seat Belts.






BLOWER MOTOR RESISTOR REPLACEMENT
The blower motor, recirculation control motor and blower resistor can be replaced without removing the blower unit. Disconnect the connector from the blower resistor, remove mounting screws, remove resistor. Reverse steps to install.