Bearing Outer Races Replacement

TOOL REQUIRED
- 07749-0010000 Driver
- 07HAD-SF10100 Driver Attachment
- Or Equivalent

NOTE:
- Replace the bearing with a new one whenever the outer race is to be replaced.
- Do not use shim(s) on the torque converter housing side.
- Adjust preload after replacing the bearing and outer race.
- Coat all parts with ATF during installation.

Transmission Housing Side





1. Remove the bearing outer race from the transmission housing by heating the housing to about 212°F (100°C).

CAUTION: Do not heat the housing in excess of 212°F (100°C).








2. Install the shim(s) and the outer race using the special tools as shown.

Torque Converter Housing Side

NOTE: The bearing outer race in the torque converter housing is not a press fit.




1. Remove the outer race from the torque converter housing, then install a new one.