Rear Door Window Glass: Service and Repair

Glass/Regulator/Glass Run Channel Replacement

1. Remove:
^ Inner trim cover
^ Door panel
^ Plastic cover

2. Connect the power window switch to the door harness.

3. Remove the corner sash trim.





4. Carefully move the glass until you can see the bolts, then remove them.





5. Remove the bolt and nut. Peel the glass run channel out of the rear channel.





6. Move the rear channel, and carefully pull the glass up.





7. Carefully remove the glass from the window slot as shown.

NOTE: Take care not to drop the glass inside the door.





8. Disconnect the connector, then remove the regulator through the center hole in the door.





9. Remove the glass run channel.





10. Remove the rear channel.





11. Remove the center channel.





12. Grease all the sliding surfaces of the regulator where shown. Check that the regulator moves smoothly by connecting a 12 V battery to the power window motor.





13. Install the glass run channel and center channel.

NOTE: Fit the glass run channel on the door as shown.





14. Install the regulator.

NOTE: Make sure the connector is connected properly.

15. Install the rear channel and glass, and fit the glass run channel into the rear channel.





16. Roll the glass up and down to see if it moves freely without binding. Also make sure that there is no clearance between the glass and glass run channel when the glass is closed. Adjust the position of the glass as necessary.





17. Attach the door harness to the door correctly.

18. When reinstalling the plastic cover, apply adhesive along the edge where necessary to maintain a continuous seal and prevent water leaks.

19. Install the door panel.