Installation

1. Before installing the steering wheel, the front wheels should be aligned straight ahead.
2. Disconnect the battery negative cable, and wait at least three minutes.






3. Set the cancel sleeve (A) so that the projections (B) are aligned vertically.






4. Carefully install the cable reel (A) on the steering column shaft. Then connect the 4P connector (B) to the cable reel, and connect the 2P connector (C) to the SRS main harness 2P connector (D).
5. Install the steering column covers.






6. If necessary, center the cable reel. (New replacement cable reels come centered.) Do this by first rotating the cable reel clockwise until it stops. Then rotate it counterclockwise (approximately two and a half turns) until the arrow mark on the cable reel label points straight up.






7. Align the projections on the cable reel with the holes on the steering wheel, and install the steering wheel with a new steering wheel bolt.
8. Install the driver's airbag.
9. Reconnect the battery negative cable.
10. After installing the cable reel, confirm proper system operation:
- Turn the ignition switch ON (II); the SRS indicator light should come on for about six seconds and then go off.
- After the SRS indicator light has come off, turn the steering wheel fully left and right to confirm the SRS indicator light does not come on.
- Make sure both horn buttons work.

11. Enter the anti-theft code for the radio, then enter the customer's radio station presets.