Recall - A/C Wiring Harness Routing: Overview

98-072

Applies To: 1995-97 Accord - ALL L4 with factory-installed A/C

October 13, 1998

Recall: Accord Wire Harness Routing
(Supersedes 98-072, dated September 21, 1998)

BACKGROUND

The factory-installed air conditioner wire harness may have been improperly routed, allowing some wires to rub against each other. Eventually, the insulation covering the wires may wear through and possibly cause a snort circuit. This could cause the under-hood wiring to overheat and smoke. In the worst case, a short circuit could cause a fire in the engine compartment

CUSTOMER NOTIFICATION

All owners of affected vehicles will be mailed a notification of this recall An example of the customer letter is at the end of this service bulletin.

CORRECTIVE ACTION

Inspect the wiring harness for damage. Install protective tubing over the wiring.

PARTS INFORMATION

Corrugated Plastic Tubing (bulk roll):
P/N 321 20-SV4-999, H/C 6049928
(One roil will repair 6O vehicles.)
For ordering purposes only.

REQUIRED MATERIALS

3M Scotch Brand Super 33 Electrical Tape:
3M P/N 054007-06132 or 054007-06133

WARRANTY CLAIM INFORMATION





Failed part: P/N 32120-SV4-A10
H/C 4548731
Defect code: 486
Contention code: K46
Skill level: Repair Technician