Blower Motor
NOTE: The blower motor, recirculation control motor, end resistor can be replaced without removing the blower assemblySRS Main Harness:
CAUTION: All SRS electrical wiring harnesses are covered with yellow outer insulation. Before disconnecting the SRS wire harness, install the short connector (5) on the airbag (5). Replace the entire affected SRS harness assembly it it has an open circuit or damaged wiring.
1. Disconnect the battery negative terminal.
2. Remove the glove box and glove box frame.
6. Disconnect the connectors from the blower motor. resistor then remove the blower.
7. Install the blower in the reverse order of removal and make sure there is no air leakage.