Harmonic Balancer - Crankshaft Pulley: Service and Repair

When installing and tightening the pulley, follow the procedure below.





Clean, remove any oil, and lubricate points shown.

Crankshaft pulley bolt size and torque value:
14 x 1.25 mm
20 Nm (2.0 kgs.cm, 14 ft.lbs.) + 90°

NOTE: Do not use an impact wrench when installing.





1. Tighten the pulley bolt to the specified torque.

Torque: 20 Nm (2.0 kgs.cm, 14 ft.lbs.)





2. Use a felt tip pen to mark the pulley bolt head and washer.





3. Tighten the pulley bolt an additional 90°.