Front

CAUTION: Check the front seat belts for damage, and replace them if necessary. Be careful not to damage them during removal and installation.

Front seat belt removal (4D):

1. Slide the front seat forward fully.
2. Remove the center pillar lower trim panel.




3. Remove the upper anchor cover and lower anchor cap.
4. Remove all the anchor bolts and the retractor bolt, remove the retractor mounting bolt, then remove the front seat belt and retractor.
5. Remove the center pillar upper trim.




6. Remove the shoulder anchor adjuster.

Upper Anchor Bolt Construction:

Lower Anchor Bolt Construction:

Retractor Bolt Construction:

7. Installation is the reverse of the removal procedure.

NOTE:
- Check that the retractor locking mechanism functions as described.
- Make sure you assemble the washers and collars on the upper and lower anchor bolts as shown.
- Before installing the anchor bolts, make sure there are no twists or kinks in the front seat belt.


Front seat belt removal (2D/3D):

1. Slide the front seat forward fully.
2. Remove:
- Rear seat-back and rear seat cushion
- Rear center shelf and rear side shelf (3D)
- Rear trim panel (3D)
- Side trim panel




3. Remove the upper anchor cover and lower anchor cap.
4. Remove all the anchor bolts and the retractor bolt, remove the retractor mounting bolt, then remove the front seat belt and retractor.

Upper Anchor Bolt Construction/Lower Anchor Bolt Construction/Retractor Bolt Construction:

5. Installation is the reverse of the removal procedure.

NOTE:
- Check that the retractor locking mechanism functions as described.
- Make sure you assemble the washers and collars on the upper and lower anchor bolts as shown.
- Before installing the anchor bolts, make sure there are no twists or kinks in the front seat belt.

Seat belt buckle removal:

1. Remove the front seat through the door opening.
2. Remove the center cover.




3. Remove the center anchor bolt, then remove the seat belt buckle.

Center Anchor Bolt Construction:

4. Driver's: Detach the seat belt switch connector and harness clip from the seat cushion. Remove the seat cushion mounting bolts from the inner seat track, and move the inner seat track, then pull the seat belt switch harness out.

NOTE: Take care not to damage the hinge bracket.

5. Installation is the reverse of the removal procedure.

NOTE: Make sure you assemble the washers and bearing on the center anchor bolt as shown.