Rear Seat Belt

CAUTION: Check the rear seat belts for damage, and replace them if necessary. Be careful not to damage them during removal and installation.

Rear seat belt removal (2D/4D):

1. Remove:
- Rear seat cushion
- Rear seat-back (2D)
- Side trim panel (2D)
- Rear shelf
- Rear trim panel
- Trunk side trim, Japan-produced
- Trunk trim panel, USA-produced




2. Remove all the anchor bolts and retractor bolt, then remove the rear seat belt and retractor.

Upper Anchor Bolt Construction/Lower Anchor Bolt Construction/Retractor Bolt Construction:

3. Installation is the reverse of the removal procedure.

NOTE:
- Check that the retractor locking mechanism functions as described.
- Make sure you assemble the washers and collar on the upper anchor bolt as shown.
- Before installing the anchor bolt, make sure there are no twists or kinks in the rear seat belt.

Rear seat belt removal (3D):

1. Remove:
- Rear seat-back and rear seat cushion
- Rear center shelf and rear side shelf
- Rear trim panel and side trim panel




2. Remove the upper anchor cover.

3. Remove all the anchor bolts and retractor bolt, then remove the rear seat belt and retractor.

Upper Anchor Bolt Construction/Lower Anchor Bolt Construction/Retractor Bolt Construction:

4. Installation is the reverse of the removal procedure.


NOTE:
- Check that the retractor locking mechanism functions as described.
- Make sure you assemble the washers and collars on the upper anchor bolt as shown.
- Before installing the anchor bolt, make sure there are no twists or kinks in the rear seat belt.

Seat belt buckle/Center belt tongue removal:

1. Remove the rear seat cushion.

2 Door/4 Door:

3 Door:

Center Anchor Bolt Construction:

2. Remove the center anchor bolts, then remove the seat belt buckles and center belt tongue.
3. Installation is the reverse of the removal procedure.

NOTE: Before attaching the seat-back and seat cushion, make sure there are no twists or kinks in the center belts.