Removal and Installation

Removal/Installation

NOTE: Before disconnecting the hoses from the pump, place a suitable container under the vehicle.





1. Remove the belt by loosening the pump mounting bolts and adjusting bolt ('99-'00 models: B16A2 Engine Type only).
2. Cover the A/C compressor with several shop towels to protect it from spilled power steering fluid.
3. Disconnect the inlet hose and the outlet line from the pump, and plug them.

NOTE: Take care not to spill the fluid on the body or parts. Wipe off any spilled fluid at once.

4. Remove the pump mounting bolts and adjusting bolt ('99-'00 models: B16A2 Engine Type only), then remove the pump.

NOTE:
- Do not turn the steering wheel with the pump removed.
- Wrap the opening of the pump with a piece of tape to prevent foreign material from entering the pump.

5. Connect the inlet hose and the outlet line. Tighten the pump fittings securely.
6. Loosely install the pump in the pump bracket with mounting bolts and adjusting bolt ('99-'00 models: B16A2 Engine Type only).





7. Install the pump belt.

CAUTION:
- Make sure that the power steering belt is properly positioned on the pulleys.
- Do not get power steering fluid or grease in the power steering belt or pulley faces. Clean off any fluid or grease before installation.

8. Adjust the pump belt.
9. Fill the reservoir to the upper level line.