Carpet: Service and Repair

SRS components are located in this area. Review the SRS component locations, precautions, and procedures before performing repairs or service.

1. Remove:
- Front seat
- Rear seat cushion
- Kick panel
- Center pillar lower trim panel (4D)
- Front seat belt lower anchor (2D/3D)
- Side trim
- Front and rear consoles
- Console panel

2. Remove the SRS unit covers.




3. Cut areas (A) and (B) in the carpet, then pull it back as shown.




4. Remove the footrest and parking brake lever mounting bolts, and detach the clips, then remove the carpet.
5. Installation is the reverse of the removal procedure.

NOTE:
- Take care not to damage, wrinkle or twist the carpet.
- Make sure the wire harnesses are routed correctly.
- If necessary, replace any damaged clips.
- Slip the carpet under the seat side trim 4D or side trim panel 2D/3D on each side properly.
- Reattach the cut areas (A) and (B) in the carpet with wire ties.