Rear Door Window Glass: Adjustments

Glass Adjustment

NOTE:
- Place the vehicle on a firm, level surface when adjusting the glass.
- Check the weatherstrips and glass run channel for damage or deterioration, and replace them if necessary.

1. Remove:
- Door panel
- Plastic cover
2. Adjust the glass.

4D:
a. Raise the glass fully.
b. Loosen the glass mounting bolts (front door) and regulator mounting bolts.
c. Push the glass rearward (front door glass) or forward (rear door glass).

Front:

Rear:

d. Tighten the glass mounting bolts (front door) and regulator mounting bolts.
e. Loosen the front channel mounting bolts (front door) or rear channel mounting bolt (rear door).
f. Lower the glass.

Front:

Rear:

g. Push the front or rear channels against the glass, then tighten the mounting bolts.

2D/3D:
a. Raise the glass as far up as possible, and hold it against the glass run channel.




b. Loosen the roller guide bolts, and adjust the glass so it is parallel with the glass run channel.
c. Tighten the roller guide bolts.
d. Loosen the front channel bolts.
e. Lower the glass.




f. Push the front channel against the glass, then tighten the mounting bolts.

3. Check that the glass moves smoothly.
4. Raise the glass fully and check for gaps.




5. Check the glass operation.

NOTE: Check that the glass contacts the glass run channel evenly.




6. Check for water leaks.
Spray water over the roof and on the sealing area as shown.

NOTE:
- Adjust the water pressure as shown.
- Do not squeeze the tip of the hose.

7. Attach the plastic cover, then install the door panel.




8. Install the regulator handle so it points forward and up at a 45 degree angle with the glass closed.