Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Pulley Removal and Installation

Special Tools Required
^ Holder handle 07JAB-001020B
^ Holder attachment, HEX 50 mm, offset 07MAB-PY3010A
^ Socket, 17 mm 07JAA-001010A or a commercially available 17 mm socket

Removal





1. Hold the pulley with holder handle (A) and holder attachment (B).
2. Remove the bolt with a heavy-duty 17 mm socket (C) and breaker bar, then remove the crankshaft pulley.

Installation





1. Clean the bolt (A), washer (B), crankshaft pulley (C) and crankshaft (D). Lubricate with new engine oil as shown.
2. Install the crankshaft pulley, and tighten the bolt to 20 Nm (2.0 kgf-m, 14 ft. lbs.).





3. Tighten the pulley bolt an additional 90°.