Reading Diagnostic Trouble Codes
How to Retrieve DTCsHDS (Honda Diagnostic System) Method
1. With the ignition switch OFF, connect the HDS to the 16P data link connector (DLC) (A).
NOTE: The 16P data link connector (DLC) is located under the dash on the passenger's side for '00-01 models, and on the driver's side for '02-05 models.
2. Turn the ignition ON (II), and follow the prompts on the HDS to display the DTC(s) on the screen. After determining the DTC, refer to the DTC Troubleshooting.
NOTE: See the HDS Help menu for specific instructions.
Service Check Signal Circuit Method
1. With the ignition switch OFF, connect the HDS to the 16P data link connector (DLC) (A).
NOTE: The 16P data link connector (DLC) is located under the dash on the passenger's side for '00-01 models, and on the driver's side for '02-05 models.
2. Short the SCS circuit to body ground using the HDS.
3. Turn the ignition switch ON (II).
4. The blinking frequency indicates the DTC. DTCs are indicated by a series of long and short blinks.
Add the long and short blinks together to determine the DTC. After determining the DTC, refer to the DTC Troubleshooting.
The system will not indicate the DTC unless these conditions are met:
^ Set the front wheels in the straight ahead driving position.
^ The ignition switch is turned ON (II).
^ The engine is stopped. The SCS circuit is shorted to body ground before the ignition switch is turned ON (II).
5. Turn the ignition switch OFF.
6. Disconnect the HDS from the DLC.