Shift Cable: Adjustments
Shift Cable Adjustment1. Remove the front console.
2. Shift the transmission into the R position.
3. Remove the nut securing the shift cable end, then separate the cable end from the shift lever.
4. Rotate the socket holder (A) on the shift cable (B) a quarter turn; the projection (C) on the socket holder faces direction to remove. Then slide the holder to remove the shift cable from the shift cable bracket base (D). Do not remove the shift cable by twisting the shift cable guide (E).
5. Push the shift cable (A) until it stops, then release it. Pull the shift cable back one step so that the shift position is in the R. Do not push and pull the shift cable by holding the shift cable guide (B).
6. Turn the ignition switch ON (II), and verify that the R position indicator light comes on.
7. Turn the ignition switch OFF.
8. Insert a 6.0 mm (0.24 inch) pin (A) through the positioning hole (B) on the shift lever bracket base and into the positioning hole (C) on the shift lever. The shift lever is secured in the R position.
9. Align the socket holder (A) on the shift cable (B) with the slot in the bracket base (C), then slide the holder into the base. Install the shift cable end (D) over the mounting stud (E) by aligning its square hole fully with the square fitting (G) at the bottom of the stud. Rotate the holder a quarter turn to secure the shift cable. Do not install the shift cable by twisting the shift cable guide
10. Verify that the shift cable end (A) is properly installed on the mounting stud (B).
11. If improperly installed, remove the shift cable from the shift cable bracket base, and reinstall the shift cable. Do not install the shift cable end on the mounting stud while the shift cable is on the shift cable bracket base.
12. Install and tighten the nut.
13. Remove the 6.0 mm (0.24 inch) pin that was installed to hold the shift lever.
14. Move the shift lever to each position, and verify that the A/T gear position indicator follows the transmission range switch.
15. Allow the wheels to rotate freely.
16. Start the engine, and check the shift lever operation in all gears.
17. Reinstall the front console.