21. Mainshaft Bearing and Oil Seal Replacement

Mainshaft Bearing and Oil Seal Replacement
Special Tools Required
^ Adjustable bearing puller, 20-40 mm 07736-A01000B
^ Oil seal driver 07JAD-PL90100
^ Driver 07749-0010000
^ Attachment, 42 x 47 mm 07746-0010300

1. Remove the differential assembly.





2. Remove the ball bearing (A) from the clutch housing (B) using the special tool and a commercially available 3/8"-16 slide hammer (C).





3. Remove the oil seal (A) from the clutch side. Be careful when removing the seal so the clutch housing is not damaged.





4. Drive in the new oil seal from the transmission side using the special tools.





5. Drive in the new ball bearing from the, transmission side using the special tools.