DTC 62-2x
DTC 62-2x (62-20 to 62-29, 62-2A to 62-2F): Sort in Front Passenger's Seat Belt Buckle Switch1. Erase the DTC memory.
2. Turn the ignition switch ON (II), then buckle and unbuckle the front passenger's seat belt several times.
3. Read the DTC.
Is DTC 62-2x indicated?
YES - Go to step 4.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. Troubleshooting Intermittent Failures
If another DTC is indicated, Go to the DTC Troubleshooting Index. Diagnostic Trouble Code Descriptions
4. Turn the ignition switch OFF.
5. Disconnect the floor wire harness 3P connector from the front passenger's seat belt buckle switch 3P connector (A).
6. Turn the ignition switch ON (II).
7. From the system selection menu on the HDS, select SRS, then select SRS again, then select DATA LIST and check the status on the HDS screen for Right Buckle Switch.
Is OPEN indicated on the HDS?
YES - Replace the front passenger's seat belt buckle assembly, then erase the DTC.
NO - Go to step 8.
8. Turn the ignition switch OFF.
9. Disconnect the negative cable from the battery, and wait for 3 minutes.
10. Disconnect both seat belt tensioner 4P connectors.
11. Disconnect both lap belt tensioner 2P connectors.
12. Disconnect SRS unit connector B (28P) from the SRS unit.
13. Check resistance between the No. 3 terminal of the floor wire harness 3P connector and body ground. There should be an open circuit or at least 1 M ohm.
Is the resistance as specified?
YES - Go to step 14.
NO - Short to ground in the floor wire harness; replace the floor wire harness.
14. Check resistance between the No. 2 terminal of the floor wire harness 3P connector and body ground. There should be an open circuit or at least 1 M ohm
Is the resistance as specified?
YES - Faulty SRS unit; Replace the SRS unit.
NO - Short to ground in the floor wire harness; replace the floor wire harness.