DTC Troubleshooting
DTC P0452: FTP Sensor Circuit Low VoltageNOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch OFF.
4. Remove the fuel fill cap.
5. Turn the ignition switch ON (II).
6. Check the FTP SENSOR in the DATA LIST with the HDS.
Is about 7.3 kPa (-2.16 in.Hg, 55 mmHg), or 0.3 V or less indicated?
YES - Go to step 10.
NO - Go to step 7.
7. Install the fuel fill cap.
8. Start the engine.
9. Monitor the OBD STATUS for DTC P0452 in the DTCs MENU with the HDS.
Does the screen indicate FAILED?
YES - Go to step 10.
NO - If the screen indicates PASSED, intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the FTP sensor and the ECM/PCM. If the screen indicates NOT COMPLETED, go to step 4 and recheck.
10. Turn the ignition switch OFF.
11. Disconnect the FTP sensor 3P connector.
12. Turn the ignition switch ON (II).
13. Check the FTP SENSOR in the DATA LIST with the HDS.
Is about 7.3 kPa (2.16 in.Hg, 55 mmHg), or 4.7 V indicated?
YES - Go to step 20.
NO - Go to step 14.
14. Measure voltage between FTP sensor 3P connector terminal No. 1 and body ground.
Is there about 5 V?
YES - Go to step 16.
NO - Go to step 15.
15. Measure voltage between ECM/PCM connector terminal E5 and body ground.
Is there 5 V?
YES - Repair open in the wire between the ECM/PCM (E5) and the FTP sensor, then go to step 22.
NO - Go to step 28.
16. Turn the ignition switch OFF.
17. Jump the SCS line with the HDS.
18. Disconnect ECM/PCM connector E (31P).
19. Check for continuity between FTP sensor 3P connector terminal No. 2 and body ground.
Is there continuity?
YES - Repair short in the wire between the ECM/PCM (E 14) and the FTP sensor, then go to step 22.
NO - Go to step 28,
20. Turn the ignition switch OFF.
21. Replace the FTP sensor.
22. Reconnect all connectors.
23. Turn the ignition switch ON (II).
24. Reset the ECM/PCM with the HDS.
25. Do the ECM/PCM idle learn procedure.
26. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0452 indicated?
YES - Check for poor connections or loose terminals at the FTP sensor and the ECM/PCM, then go to step 1.
NO - If Temporary DTC or DTC P0452 is not indicated, or if any other Temporary DTCs or DTCs are indicated/go to step 27.
27. Monitor the OBD STATUS for DTC P0452 in the DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES - If there was no Temporary DTCs or DTCs indicated on step 26, troubleshooting is complete. If any other Temporary DTCs or DTCs was indicated on step 26, go to the indicated DTC's troubleshooting.
NO - If the screen indicates FAILED, check for poor connections or loose terminals at the FTP sensor and the ECM/PCM, then go to step 1. If the screen indicates NOT COMPLETED, go to step 25 and recheck.
28. Update the ECM/PCM if it does not have the latest software, or substitute a known-good ECM/PCM.
29. Start the engine.
30. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0452 indicated?
YES - Check for poor connections or loose terminals at the FTP sensor and the ECM/PCM. If the ECM/PCM was updated, substitute a known-good ECM/PCM, then go to step 29. If the ECM/PCM was substituted, go to step 1.
NO - If Temporary DTC or DTC P0452 is not indicated, or if any other Temporary DTCs or DTCs are indicated, go to step 31.
31. Monitor the OBD STATUS for DTC P0452 in the DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES - If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM. If any other Temporary DTCs or DTCs was indicated on step 30, go to the indicated DTC's troubleshooting.
NO - If the screen indicates FAILED, check for poor connections or loose terminals at the FTP sensor and the ECM/PCM. If the ECM/PCM was updated, substitute a known- good ECM/PCM, then go to step 29. If the ECM/PCM was substituted, go to step 1. If the screen indicates NOT COMPLETED, let the engine idle until a result comes on.