Rear Seat Cushion Cover/Pad Replacement

Rear Seat Cushion Cover/Pad Replacement

Special Tools Required

KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

NOTE:
- Put on gloves to protect your hands.
- Take care not to tear the seams or damage the seat covers.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- The left seat cushion is shown; the right seat cushion is similar.

1. Remove the rear seat assembly.
2. Remove the rear seat cushion.




3. Remove the screws, remove the leg cover (A) while pulling leg pin portions (B) outward.




4. Remove the under cover cap (A).




5. Remove all of the screws (A, B). Release the edge of the seat-back cover (C) all the way around from the undercover (D).




6. Remove the undercover (A).




7. Release the hook strips (A) of the seat cushion cover (B) from the seat cushion frame (C).




8. Remove the screw (A) and detach the clip (B), then remove the recline cover (C)




9. Remove the seat cushion cover/pad (A) and silencer (B) from the seat cushion frame (C).
10. Reinstall the seat cushion cover/pad in the reverse order of removal, and note these items:
- To prevent wrinkles in the seat cushion cover, stretch the material evenly over the pad.
- Check if the clip is damaged or stress-whitened, and if necessary, replace it with a new one.