Harmonic Balancer - Crankshaft Pulley: Service and Repair
Crankshaft Pulley Removal and InstallationSpecial Tools Required
^ Holder handle 07JAB-001020A
^ Crankshaft pulley holder 070AB-RJA0100
^ Socket wrench, 19 mm 07JAA-001020A
Removal
1. Remove the front wheels.
2. Remove the splash shield.
3. Remove the drive belt.
4. Hold the pulley with handle (A) and holder attachment (B).
Installation
1. Clean the crankshaft pulley (A), crankshaft (B), bolt (C), and washer (D). Lubricate as shown below.
2. Install the crankshaft pulley.
3. Tighten the crankshaft pulley bolt. Do not use an impact wrench.
- 1 Hold the pulley with the holder handle (A) and pulley holder attachment (B), then tighten the bolt to 37 N.m (3.8 kgf.m, 27 lbf.ft) with a torque wrench and a heavy duty 19 mm socket (C). If the pulley bolt or crankshaft are new, tighten the bolt to 177 N.m (18.0 kgf.m, 130 lbf.ft), then remove the bolt and tighten it to 37 N.m (3.8 kgf.m, 27 lbf.ft).
- 2 Mark the bolt head (D) and the crankshaft pulley (E) as shown, then tighten the bolt an additional 90° (The mark on the bolt head line up with the mark on the crankshaft pulley).
4. Install the drive belt.
5. Install the splash shield.
6. Install front wheels.