Horn Switch Test
Horn Switch Test1. Remove the steering column covers.
2. Disconnect the dashboard wire harness 5P or 13P connector (A) from the cable reel (B)
3. Using a jumper wire, connect the No. 1 terminal of the dashboard wire harness 5P or 13P connector to body ground. The horn should sound.
- If the horn sounds, go to step 4.
- If the horn does not sound, check these items:
- No. 16 (15 A) fuse in the under-hood fuse/relay box.
- Horn relay.
- Horn.
- An open in the wire.
4. Reconnect the dashboard wire harness 5P or 13P connector (A) to the cable reel (B)
5. Remove the driver's airbag assembly.
6. Using a jumper wire, connect the 1P connector (C) to body ground.
- If the horn sounds, replace the driver's airbag assembly.
- If the horn does not sound, replace the cable reel.