Starter Solenoid: Testing and Inspection
Starter Solenoid Test1. Make sure you have the anti-theft code for the audio unit, then write down the audio presets.
2. Disconnect the negative cable from the battery first, then disconnect the positive cable.
3. Remove the starter cable terminal (A), BLK/WHT wire connector (B), and motor cable (C).
4. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). There should be continuity.
- If there is continuity, go to step 5.
- If there is no continuity, replace the solenoid.
5. Check the pull-in coil for continuity between the S terminal and the M terminal. There should be continuity.
- If there is continuity, the solenoid is OK.
- If there is no continuity, replace the solenoid.
6. Install in the reverse order of removal.
7. Connect the positive cable to the battery first, and then connect the negative cable.
8. Enter the anti-theft code for the audio unit, then enter the audio presets.
9. Set the clock.