Seat Occupant Sensor: Service and Repair

Passenger's Weight Sensor Replacement

Removal ('06-07 Models)

NOTE: Removal of the passenger's weight sensors must be performed according to the precautions/procedures described at the beginning of SRS.

1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
2. Remove the passenger's seat assembly.




3. Remove the TORX bolts (A) attaching the seat track (B) to the weight sensors (C).
4. Disconnect the sensors connectors (D) from the weight sensor unit, then remove the passenger's weight sensors.

Installation

NOTE: Be sure to install the harness wires so they are not pinched or interfering with other parts.




1. Install the new passenger's weight sensors with TORX bolts (A) under the seat track.
2. Reinstall the passenger's seat.
3. Reconnect the negative cable to the battery.
4. Calibrate the passenger's weight sensor unit.
5. After installing the passenger's weight sensors, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come for about 6 seconds and then go off.