Dynamic Damper Replacement

Dynamic Damper Replacement

1. Remove the inboard joint.
2. Remove the double loop band or low profile bands.

^ If the band is a welded type, cut the band.
^ If the band is a double loop type, lift up the band end, then push it into the clip.
^ If the band is a low profile type, pinch the band using a commercially available boot band pliers.

3. Remove the dynamic damper.








4. Install the new dynamic damper and adjust the position of the new dynamic damper to these measurements.








5. Install a new double loop band (replacement part only).
6. Install the inboard joint.